SELECT u_spring.springid, u_spring.line_diameter, u_spring.height, u_spring.height_original, u_spring.caliber, u_spring.center_diameter, u_spring.cyclenum, u_spring.gram_weight, u_spring.dscrp, u_spring.createtime, u_spring.createby, u_spring.tempqty, u_spring.bedtypeid, u_spring.his_typeid, u_spring.springtypeid, u_spring.flag, u_spring.inuse, u_spring.modemp, u_spring.moddate, u_spring.free_height, u_spring.actual_height, u_spring.hardness, u_spring.hardness_indentation_1, u_spring.hardness_indentation_2, u_spring.hardness_indentation_4, u_spring.arrangement_width, u_spring.arrangement_height, u_spring.roll_width, u_spring.roll_length, u_spring.comperssion_rate, CASE WHEN springname <> '' THEN springname WHEN u_springtype.springtypecode <> '' THEN rtrim(u_springtype.springtypecode) + '/'+ left(rtrim(cast(u_spring.height_original as char(10))),2) + '/'+ left(rtrim(cast(u_spring.height as char(10))),2) + '/'+ left(rtrim(cast(u_spring.caliber as char(10))),4) + '/'+ left(rtrim(cast(u_spring.center_diameter as char(10))),3) + '/'+ left(rtrim(cast(u_spring.cyclenum as char(10))),1) + '/'+ left(rtrim(cast(u_spring.line_diameter as char(10))),3) + '-'+ left(rtrim(cast(u_spring.hardness as char(10))),5) ELSE left(rtrim(cast(u_spring.line_diameter as char(10))),4) + '/'+ left(rtrim(cast(u_spring.height as char(10))),4) + '/'+ left(rtrim(cast(u_spring.caliber as char(10))),4) + '/'+ left(rtrim(cast(u_spring.center_diameter as char(10))),4) + '/'+ left(rtrim(cast(u_spring.cyclenum as char(10))),4) END AS springname, u_springtype.springtypecode, u_springtype.springtypename, CASE WHEN hardness <= 8 THEN '软' WHEN hardness <= 11 THEN '中软' WHEN hardness <= 15 THEN '适中' WHEN hardness <= 20 THEN '中硬' ELSE '硬' END AS hardness_level FROM u_spring INNER JOIN u_springtype ON u_springtype.springtypeid = u_spring.springtypeid u_spring.his_typeid = 1 u_spring.springtypeid = @springtypeid u_spring.bedtypeid = @bedtypeid u_spring.cyclenum = @cyclenum u_spring.center_diameter = @center_diameter u_spring.caliber = @caliber u_spring.height = @height u_spring.line_diameter = @line_diameter 序 弹簧名称 弹簧类型 类型编码 软硬程度 线径MM 高度CM 入袋前高度CM 口经CM 中心直径CM 圈数 克重KG 床网类型 弹簧分类 备注 等记人 登记时间 审核 禁用 修改人 修改时间 自由高度 实际高度 硬度 压陷硬度10% 压陷硬度20% 压陷硬度40% 排列宽 排列长 卷排列宽 卷排列长 压缩比